WONDERWAVES WATER WAVE IRON

ELECTRICAL

Reference:

IDEBBL-190

Description: Thanks to WonderWaves you can have an impeccable look as if it was done by a professional. You will easily achieve spectacular, fast, defined...

€189.00

Tax included

Quantity

In Stock

Description

Thanks to WonderWaves you can have an impeccable look as if it was done by a professional. You will easily achieve spectacular, fast, defined and marked water waves. And thanks to its HairCare technology, you can create your waves with a very short exposure to heat, in just 10 seconds, this caring for the health and hydration of your hair.

- TPC Technology: Ultra fast heating.
- HairCare Technology: Maximum hair care...
- Aluminium plates with ceramic coating: uniform temperature.
- 54mm wide plates.
- Half the power consumption.
- Twice as fast and efficient.
- LED temperature indicator lights.
- 5 temperature levels.
- Temperature range 150º - 210ºC.
- Overheat protection.
- Automatic shut-off after 60 min.
- 360º swivel cable.
- Cable length: 1,6m.
- Ecofriendly.
- Voltage: 220 - 240 V~.
- Frequency: 50/60 Hz.
- Power: 82 W.

Product Details

How to use

1. Switch on the device: Connect the device to the power supply and switch on the device with the power button.
2. Allow the appliance to heat up. The default heat setting is 150℃.
3. When the temperature setting shows 150℃, you can adjust the temperature according to your preference:
Press the "+" button to increase the temperature or press the "-" button to decrease the temperature.
You can change 10℃ at a time by pressing the "+/-" button. The display will indicate the temperature you have selected.
4. Press the power button twice quickly, the temperature will be locked. Press the power button twice quickly again, the temperature is then unlocked.
5. Comb the hair.
6. Divide your hair into approximately 5 cm wide strands.
7. Hold the appliance by the handle, always at a safe distance from skin and eyes. Use a mirror.
8. Start at the roots and place the strand (one at a time) between the plates and press firmly.
9. 10 seconds later, release the hair, the curve will show on the hair. Repeat that procedure from the roots to the ends of your hair until you get the desired result.
10. After you have finished working all the hair, let it cool down. Then you can comb it, apply hairspray, etc.
11. Switch off the appliance with the off switch and disconnect it from the power supply.
12. Allow the appliance to cool down completely on a heat-resistant surface before storing it.
13. Clean the appliance with a damp cloth once it is cool and unplugged.